Clean up wasteland program
Opening up wasteland is the first clean project, because construction projects often leave a lot of garbage dirt, a variety of ground stones, walls will leave cement slurry, paint, glass glue, water pollution, rust, and so on, these must be cleaned up in the work of opening up wasteland, so it is the most difficult, most complex, the most demanding work. The quality and grade of cleaning work will be directly affected by the quality of the reclamation project, so it is very important to do a good job of reclamation.
1, first of all, clean up the garbage left on the scene.
2, from top to bottom, full dust collection;
3. Wipe the glass: wipe the glass frame clean with towel first, then dip the diluted glass water solution with water applicator, smear the glass evenly from top to bottom, remove stubborn stains with a spade, and then repeat the above procedures with a scraper from top to bottom, wipe the water marks left on the frame with dry towel, water marks on the glass Wipe with machine skin.
4, toilet: Adhere to the principle of top-down, first of all, recognize the material of the toilet top, PVC or aluminum-plastic board or paint, and then according to different materials with different cleaning methods; clean the toilet wall with cleaning balls or board brushes, focusing on the cracks in ceramic tiles, and ceramic tile surface remains of the glue Use towels to clean toilet sanitary ware and stainless steel cleaning fluid to clean all kinds of taps and pipe fittings. Use a floor washing machine to clean the floor at the end of the corner of the floor. Finally, after checking for no omissions, wipe the taps and other pipe fittings with a dry towel.
5, kitchen: the same procedure. Attention: because the stainless steel pipe in the kitchen is more, it should be the key of cleanliness.
6. Bedroom and Hall: duster with duster, wipe the switch box, etc.
7. Door and frame: distinguish the material of the door, wipe it with towel, the procedure is from top to bottom, fold the towel into a square, wipe it from the top of the door from left to right, can not be omitted
8. Ground cleaning: After all is done, the ground is cleaned, the ground must also be divided into material, is the wood floor, or tile, or stone, when the distinction after the choice of special cleaning agent dilution, start cleaning. The glue stains on the ground can be removed with a knife blade, and the stubborn glue remover can be used to deal with them. After the last process is completed, the foreman should check them thoroughly and then leave the site after confirming that there is no left behind.
9, the ground line: wipe with a towel, (with the blade to remove various traces of glue, paint points, etc.).